RUN mode

1. Move X and Y table position so spindle centerline is over program absolute zero. In DRO set X and Y absolute to zero
2. Select START to run program starting at event 1.
3. Select START EVENT # to run program starting at an event other than 1.
4. Use and to increase or decrease the feedrate by 10% increments.
5. SET Z prompts you to drill and retract the quill for a drilling operation or set and lock the quill at the proper depth for a milling operation. Press GO to continue.
6. CHECK Z prompts you to make sure the quill is properly retracted before the next rapid move. Press GO to continue.
7. Press STOP to halt the program run. Press GO to continue.
8. RUN OVER means the program is complete.
9. DATA ERROR means check program because it is impossible to run as programmed.
10. FAULT means the ProtoTRAK has discovered a problem in its self diagnosis. Consult the service manual.